EUVIMEDEUVIMED entdecken
CrossrefInfokarte

Marginal gap of three-dimensional printed full-arch frameworks supported by all-on-four and all-on-six implant designs

Leticia Del Rio Silva, Thaís Barbin, Daniele Valente Velôso, Marcelo Ferraz Mesquita, Guilherme Almeida Borges

The Journal of Indian Prosthodontic Society · 2025-07 · 25 (3) · 191-197

DOI: 10.4103/jips.jips_40_25 ↗
AbstractBibliografische Angaben

Abstract

Aim: The aim of this study was to evaluate the marginal gap of full-arch frameworks (FAFs) supported by all-on-four and all-on-six implant designs, fabricated using different manufacturing technologies. Settings and Design: This was an in vitro study. Materials and Methods: Fifteen titanium FAFs were fabricated using milling and three-dimensional printing techniques: selective laser melting (SLM) and electron beam melting (EBM) ( n = 5/group). The marginal gap between the framework and abutment was measured using a microscope with 1 μm accuracy. Measurements were taken three times by a calibrated examiner (intraclass correlation coefficient of 0.996; P < 0.001) at the buccal and lingual interface between the abutment and the framework. Statistical Analysis Used: A two-way ANOVA was applied to assess the effects of implant design and manufacturing technology (α = 0.05). Results: When comparing implant designs, the all-on-four group (milling [ P = 0.002] and SLM [ P = 0.001]) exhibited lower marginal gap values than the all-on-six group. No statistically significant difference was observed between the EBM frameworks in both designs. In the all-on-four group, milling resulted in lower marginal gap values than SLM ( P = 0.021) and EBM ( P = 0.001), while no statistically significant difference was found between the SLM and EBM groups ( P = 0.163). For the all-on-six framework design, the milling ( P = 0.008) and EBM ( P < .001) groups exhibited lower marginal gap values than the SLM group. No statistically significant difference was detected between the milling and EBM groups ( P = 0.160). Conclusion: Milled frameworks should be the preferred choice for rehabilitations using the all-on-four implant design. For the all-on-six design, both milled and EBM frameworks may be indicated. The marginal gap values observed for all FAFs designs and manufacturing technologies can be considered clinically acceptable.

Wissen, das zu Ihrer Arbeit passt.

Vom kostenlosen Einstieg über die persönliche Recherche bis zur vollständigen Research Suite.

Tarife ansehen →

Sind alle Verlagsvolltexte enthalten?

Nein. Bibliografische Nachweise, Abstracts und Volltexte sind unterschiedliche Inhalte. Ob ein Volltext verfügbar ist, hängt von der Quelle, Open Access und Ihren vorhandenen Lizenzen ab. Ein EUVIMED-Tarif ersetzt keine zusätzlichen Verlagsrechte.

Tarife ansehen →