Timing Feasibility of Multimodal Software-Defined Haptic Rendering with a Browser-Based Digital Twin on a Cortex-M4 Microcontroller
Electronics · 12.11.2026 · 15 (22) · 5270
DOI: 10.3390/electronics15225270 ↗Kurz gefasst
Fachartikel in der Zeitschrift Electronics, online erschienen am 12.11.2026. Verfasst von Victor H. Benitez und 7 weiteren Autor:innen. Die Arbeit nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Facultad Interdisciplinaria de Ingeniería, Universidad de Sonora.
Abstract (Originalsprache)
Haptic interfaces convey force between an operator and a physical or virtual environment, yet passive devices encode a single force behavior in dedicated mechanical hardware and cannot emulate qualitatively different phenomena without physical modification. This study presents a software-defined haptic platform that renders four models on a single low-cost 32-bit microcontroller without hardware reconfiguration. A deterministic 1 kHz interrupt-driven control loop drives a motorized linear slider through an H-bridge and renders virtual detents, square-root position-dependent resistance, a one-dimensional reaction–diffusion field solved by explicit finite differences, and a symmetric square-root spring. A browser-based three-dimensional visualization, synchronized with the embedded state over a one-way serial link, forms a shadow Digital Twin, and a two-level limit-switch layer provides end-of-travel protection. The loop period, the worst-case execution time of the field solver, and the telemetry interval were measured on the deployed firmware. The control loop held its 1 ms period with microsecond-level jitter while streaming telemetry to the Digital Twin at approximately 5 Hz, and the field solver consumed less than 8% of the interrupt budget. These results show that reconfigurable multimodal haptic rendering can be scheduled deterministically on resource-constrained embedded hardware, whereas the physical fidelity of the rendered behaviors remains to be validated.
Förderung
- Facultad Interdisciplinaria de Ingeniería, Universidad de Sonora
Zitieren
APA
Benitez, V. H., Karlett-Ramos, W. N., Salcido-Munguia, D. A., Suarez-Sanchez, F. A., Denogean, C. A., Balderrama-Alvarez, D. A., Solis, D., & Pacheco, J. (2026). Timing Feasibility of Multimodal Software-Defined Haptic Rendering with a Browser-Based Digital Twin on a Cortex-M4 Microcontroller. Electronics, 15(22), 5270. https://doi.org/10.3390/electronics15225270
Vancouver
Benitez VH, Karlett-Ramos WN, Salcido-Munguia DA, Suarez-Sanchez FA, Denogean CA, Balderrama-Alvarez DA, et al. Timing Feasibility of Multimodal Software-Defined Haptic Rendering with a Browser-Based Digital Twin on a Cortex-M4 Microcontroller. Electronics. 2026;15(22):5270. doi:10.3390/electronics15225270
BibTeX
@article{Benitez2026,
author = {Benitez, Victor H. and Karlett-Ramos, Wendy N. and Salcido-Munguia, Daniel A. and Suarez-Sanchez, Fernando A. and Denogean, Cesar A. and Balderrama-Alvarez, Daniel A. and Solis, David and Pacheco, Jesus},
title = {Timing Feasibility of Multimodal Software-Defined Haptic Rendering with a Browser-Based Digital Twin on a Cortex-M4 Microcontroller},
journal = {Electronics},
year = {2026},
volume = {15},
number = {22},
pages = {5270},
doi = {10.3390/electronics15225270}
}
EUVIMED