Marginal Adaptation of Self-Cure and Light-Cured Class II Resin Composites
Operative Dentistry · 2026-09 · 51 (5) · 465-478
DOI: 10.2341/26-032-l ↗Abstract
ABSTRACT Purpose: Marginal breakdown at cervical dentin-based gingival margins remains a leading cause of failure in Class II resin composite restorations, and it is not established whether a self-cure bulk-fill placement technique provides better marginal adaptation than a conventional light-cured incremental technique at these vulnerable margins. The purpose of this study was to evaluate the marginal adaptation of a self-cure bulk-fill resin composite and an incrementally placed light-cured injectable resin composite in Class II cavities with proximal gingival margins located in enamel and dentin. Methods and Materials: Standardized Class II cavities were prepared on the mesial and distal surfaces of 16 extracted mandibular human molars, with one gingival margin in enamel (1 mm coronal to the CEJ) and one in dentin (1 mm apical to the CEJ) in each tooth. Teeth were randomly assigned to two groups (n = 8 per group, one surplus tooth excluded): a self-cure bulk-fill group (Stela Automix with Stela Primer, SDI Ltd., Bayswater, Victoria, Australia) and a light-cured incrementally placed group (G-ænial Universal Injectable with G-Premio Bond, GC Corporation, Tokyo, Japan). Margins were analyzed before and after thermocycling (5,000 cycles, 5°C-55°C) using scanning electron microscopy of epoxy resin replicas. Marginal adaptation was quantified as the percentage of continuous margins (%CM). Data were analyzed using a three-way mixed-design ANOVA with Bonferroni-adjusted simple-effects comparisons (α = 0.05). Results: Margin location ( p < 0.001) and thermocycling ( p < 0.001) significantly influenced %CM, and a significant restorative system × margin location interaction was found ( p = 0.003). At enamel margins, the two systems did not differ before or after thermocycling ( p ≥ 0.333). At dentin margins, the self-cure bulk-fill system showed significantly higher %CM than the light-cured incremental system both before (95.75 ± 0.94 versus 93.36 ± 1.83; p = 0.011) and after thermocycling (93.03 ± 1.81 versus 90.50 ± 1.96; p = 0.036). Thermocycling reduced %CM for both systems at both margin locations, to a similar extent (restorative system × thermocycling interaction, p = 0.891). Conclusions: The self-cure bulk-fill resin composite demonstrated superior marginal adaptation at dentin margins compared with the incrementally placed light-cured injectable resin composite, both before and after thermocycling. Both systems performed comparably at enamel margins. Thermocycling reduced the marginal adaptation of both systems to a similar degree.
EUVIMED